Table of Contents
Advertisement
7.2.1
Log-on/Log-out
You can log on to the device in the "Log-on/Log-out" submenu. Depending on the rights required, this is
necessary to change device settings and to perform calibrations. When you are logged in, the logged-in
user is shown in the header of the measurement display.
In addition, you can log out again or change passwords in the "Log-on/Log-out" submenu. The password
for a user can be changed only when the user is logged in.
Factory-set passwords
Users
Factory-set password
Default rights
Logon
Accessing a menu: Device menu > Log-on/Log-out > Logon
After Logon opens, the device requires that a user be selected (flashing user name). Use the "Up" and
"Down" operating keys to select the desired user and confirm by pressing the "OK" operating key. The
password is requested next (flashing display). The password is a numerical value. You use the "Up" and
"Down" operating keys to change the password. Press the "OK" operating key to confirm the entry.
After successful logon, the logged-in user appears in the header (flashing) in the measuring mode.
Logoff
Accessing a menu: Device menu > Log-on/Log-out > Logout
Accessing the Logout menu logs off the logged-in users from the device. The device then indicates suc-
cessful logoffs in the display and you can use the "Back" operating key to return to the menu hierarchy
or measured value display.
Changing password
Accessing a menu: Device menu > Log-on/Log-out > Change password
Passwords can only be changed for logged-in users. First log on the user whose password is to be
changed.
Once you have accessed "Change password", you are requested to enter a new password for the
logged-in user (flashing password value "0"). You now use the "Up" and "Down" operating keys to
change the password value to the desired value. Finally, you confirm the new password by pressing "OK"
operating key. The device then indicates successful acceptance of the new password and you can use
the "Back" operating key to return to the menu hierarchy or measured value display.
7.2.2
Calibration
You can find all functions for calibrating your sensor in this menu. A detailed description of the calibration
procedure can be found in the section chapter 9 "Calibration", page 47.
Administrator
9200
•
General operation
(measuring mode and device
information)
•
Calibration rights
•
Administrator rights
7 Operation
User
300
•
General operation
(measuring mode and device
information)
43
Advertisement
Table of Contents
