Technical Specification - Stuart Turner STUART PH 35 TS Installation, Operation & Maintenance Instructions Manual

5 TECHNICAL SPECIFICATION

Pump Model
General Guarantee
WRAS approval
Approvals
Pump type
Features
Priming vent plug
Typical noise
Materials Pump body
Impeller
Mechanical seal
Performance Maximum head - closed valve
Performance @ 9 l/min
Performance @ 18 l/min
Maximum flow
Minimum static inlet pressure
Maximum static inlet pressure
Maximum working pressure*
Maximum viscosity
Maximum ambient air temperature
Min / Max water temperature
Maximum suction lift**
Connections Pump connections
Motor Type
Duty rating
Electrical Power supply (Vac/Ph/Hz)
Power consumption - P1
Current - full load
Fuse rating
Power cable length
Physical Enclosure protection
Length
Width
Height - excluding hoses
Weight - including fittings
PH 35 TS PH 35 TS
50 Hz 50 Hz
46496 46445
Approved materials
ü ü
Viton / Carbon
EPDM / PTFE /
/ Silicon
Al. Oxide
Carbide
3.0 bar / 30 metres
2.3 bar / 23 metres
1.4 bar / 14 metres
34 l/min
0.05 bar (0.5 metres)
1.4 bar (14 metres)
50 secs redwood no. 1 9.5 centistokes
Min 4
Induction, auto-reset thermal trip
Continuous (S1) @ 2.5 l/min and above
230 V a.c. / 1 / 50 Hz
410 Watts
1.8 Amps
1.5 metres (pre-wired)
209 mm
4.4 Kg
- 11 -
PH 45 TS
50 Hz
46504
2 years
CE
Peripheral
ü
56 dB(A)
Brass
Brass
EPDM / PTFE /
Al. Oxide
4.2 bar / 42 metres
3.3 bar / 33 metres
2.4 bar / 24 metres
44 l/min
600 kPa (6 bar)
40 C
o
C / Max 80 C
o o
4.6 metres
G ¾ female
600 Watts
2.6 Amps
5 Amps
IP44
225 mm
132 mm
169 mm
6.0 Kg
PH 45 TS
50 Hz
46448
ü
Viton / Carbon
/ Silicon
Carbide
Cont ...