Download Print this page

Dakota Digital Commander Series Manual page 9

Remote control entry system
Hide thumbs Also See for Commander Series:

Advertisement

Drv. Win. Up/Down
Activate Auxiliary Output
Drv. Door Latch
OPERATION FOR MODE 1, DIP switch #1 OFF
The key chain transmitter has five buttons. They are referred to below as button 1, 2, 3,
4, and 5. Buttons 1 and 2 are on the top, to the right and left of the green light. Buttons 3, 4,
and 5 are below them with button 5 in the bottom center.
Button 1 controls the driver's window. The first time it is pressed it will roll the window
down until the button is released. The next time it is pressed it will roll the driver's window up
until it is released. Button 2 controls the passenger's window. It works the same as button 1,
reversing the window direction each time it is pressed.
Button 3 releases the driver's door latch. It will send 12 volts to the actuator for about
one second. The relay is turned off automatically to prevent burning out the latch release
actuator. Button 4 releases the passenger's door latch. It will send 12 volts for approximately
one second.
Button 5 Trunk latch application: Pressing button 5 will activate the third internal relay
for about one second. The white w/blue and white w/red wires should not be used.
Button 5 Trunk lift, lock/unlock, or similar: The first time the button is pressed it will
raise the trunk (or unlock doors) until it is released. The next time it is pressed it will lower the
trunk, (or lock doors) until it is released. The purple wire should not be used.
Button 1 and 3 pressed at the same time will activate an extra relay which can be used
to operate almost any accessory. When DIP switch #2 is off, the relay will remain on as long
as the buttons are held. When the buttons are released it will turn off. When DIP switch #2 is
on, the relay will turn on and remain on the first time the buttons are pressed. The next time
the buttons are pressed the relay will turn off.
When the ignition key is on, the only buttons that will work are 1 and 2. Buttons 3, 4, 5,
and 1-3 are disabled. This safety feature will not allow the doors or trunk to accidentally
release while the vehicle is in motion. This disables the key chain transmitter only. The
emergency release switch will not be disabled.
Trunk Latch
Pass. Win Up/Down
1
2
3
4
5
Trunk Raise/Lower
9
Pass. Door Latch

Advertisement

loading

This manual is also suitable for:

Cmd-9000