Advertisement
Drv. Win. Up/Down
(Trunk Raise)
Drv. Door Latch
(Trunk Latch)
OPERATION FOR MODE 2, DIP switch #1 ON
The key chain transmitter has five buttons. They are referred to below as button 1, 2, 3,
4, and 5. Buttons 1 and 2 are on the top, to the right and left of the green light. Buttons 3, 4,
and 5 are below them with button 5 in the bottom center.
Button 1 controls the driver's window. The first time it is pressed it will roll the window
down until the button is released. The next time it is pressed it will roll the driver's window up
until it is released. Button 2 controls the passenger's window. It works the same as button 1,
reversing the window direction each time it is pressed.
Button 3 releases the driver's door latch. It will send 12 volts to the actuator for about
one second. The relay is turned off automatically to prevent burning out the latch release
actuator. Button 4 releases the passenger's door latch. It will send 12 volts for approximately
one second.
Button 5 activates the alternate functions for each button. Press and release button 5
and then press one of the other buttons for the functions listed below.
Pressing button 5, and then button 1 will activate an external relay to raise a trunk lift,
unlock doors, or any other function. It will remain on until the button is released.
Pressing button 5, and then button 2 will activate an external relay to lower a trunk lift,
lock doors, or any other function. It will remain on until the button is released.
Pressing button 5, and then button 3 will activate an internal relay to send 12 volts out
on the purple wire for about 1 second.
Pressing button 5, and then button 4 will activate an extra external relay which can be
used to operate almost any accessory. When DIP switch #2 is off, the relay will remain on as
long as the button is held. When the button is released it will turn off. When DIP switch #2 is
on, the relay will turn on and remain on the first time the buttons are pressed. The next time
the buttons are pressed the relay will turn off.
When the ignition key is on, the only buttons that will work are 1 and 2. Buttons 3, 4,
and 5 are disabled. This safety feature will not allow the doors or trunk to accidentally release
while the vehicle is in motion. This disables the key chain transmitter only. The emergency
release switch will not be disabled.
Pass. Win Up/Down
(Trunk Lower)
1
2
3
4
(Auxiliary Output)
5
Activate Alternate Function
Shown in ( )
10
Pass. Door Latch
Advertisement
