Advertisement
INSTALLATION
The receiver should be mounted on the interior of the vehicle so that it is not exposed to
moisture. It can be secured using the four mounting holes or with a double sided adhesive
tape, such as Velcro. The main harness plugs into one end of the unit with a 14 pin connector
and the antenna plugs into the other end with a phone-style connector. The antenna should be
mounted away from any power wires.
The color code for the main harness is listed below. The unit only needs the red and
black wires connected to operate. The others should be hooked up according to your
application. The CMD-9000 should only be connected to a 12 volt battery for power and never
solely to a battery charger.
RED
BLACK
YELLOW
BROWN
BLUE
GREEN
PURPLE
WHITE/RED
WHITE/BLUE
ORANGE
PINK
WHITE
GRAY
WHITE/GREEN
The blue, green, and purple wires are connected to internal relays and can feed 12 volts
out at up to 10 amps for the full pulse duration, 15 amps briefly. The white, gray, orange, pink,
white w/ green strip, white w/ red strip, and white w/ blue strip are negative switched outputs
designed to only turn on external relays. This combination of internal and external relays was
used to reduce the number of wires going through the door jams to a minimum. To eliminate
having any wires running through your door jams, use DAKOTA DIGITAL MAGNUM
SHOOTERS. Refer to the following diagrams for connection to your particular actuators and
power windows.
use a flexible rubber tube
to protect the wires.
Wiring through door jamb
constant 12 volt battery source
chassis ground
ignition key switched 12 volts
driver's window emergency switch
driver's door latch actuator
passenger's door latch actuator
trunk release latch actuator
trunk lift motor raise relay
trunk lift motor lower relay
passenger's window up relay
passenger's window down relay
driver's window up relay
driver's window down relay
auxiliary relay output
door
door
jamb
allow slack for door to open fully
door
jamb
Using MAGNUM SHOOTERS!
2
door
Advertisement
