Advertisement
POWER DOOR LOCK WIRING
NOTE: If no switch is to be used,
GROUND the brown and white wires.
GROUND-AT-REST Switch -
contact positions vary with style
CHASSIS
GROUND
CONSTANT-ON
+12V (BATT)
CHASSIS
GROUND
Figure 11. Connection to power door locks with a 5-wire switch.
WIRING TO RELEASE 4 DOOR LATCHES
Buttons 1 and 2 will operate door latch releases instead of window up/down. For
solenoids which require more than 10 amps, such as Dakota Digital's PDR-2, an external relay
should be used for powering the solenoids on outputs 3 and 4. (see figure 3.)
CONSTANT-ON
FUSED +12V
CHASSIS
CONSTANT-ON
FUSED +12V
ACTIVATED WHEN BUTTON 1 IS PRESSED
TO DOOR LATCH RELEASE
TO DOOR LATCH RELEASE
ACTIVATED WHEN BUTTON 2 IS PRESSED
DO NOT CONNECT
DO NOT CONNECT
Figure 12. Connection for operating four door latch releases.
CONSTANT-ON
FUSED +12V
TO CONSTANT-ON
+12V (BATT.)
RED
BLACK
GROUND
PURPLE
BLUE
small wire
DUAL
BLUE
RELAY
RED
GREEN
PACK
BROWN
WHITE
GREEN
small wire
RED
BLACK
CHASSIS
GROUND
PURPLE
DUAL
BLUE
RELAY
GREEN
PACK
BROWN
WHITE
BLUE
GREEN
CONNECT WHITE AND GRAY
WHITE
WIRES TOGETHER
GRAY
CONSTANT-ON
FUSED +12V
PINK
CONNECT ORANGE AND PINK
WIRES TOGETHER
ORANGE
8
BLUE
WHITE/BLUE
small wire
RED
CONSTANT-ON
FUSED +12V
GREEN
WHITE/RED
small wire
ACTIVATED WHEN BUTTON 3 IS PRESSED
TO DOOR LATCH RELEASE
TO DOOR LATCH RELEASE
ACTIVATED WHEN BUTTON 4 IS PRESSED
If high current solenoids (>10A) are
being used, then wire another dual
relay pack here as shown in Fig. 3.
Advertisement
