Replacing The Lvds Converter Board - GE MAC 3500 Service Manual

Maintenance

Replacing the LVDS Converter Board

Use the following procedure to replace the LVDS converter board required by the AUO
LCD display (P/N 2062075–001).
1. Remove the display assembly from the device.
See
2. Disconnect all cables from the LVDS converter board.
3. Remove the screws fastening the LVDS converter board to the display assembly.
NOTE:
4. Attach the new LVDS converter board to the display assembly using the two
screws removed in step 3.
5. Reconnect all the cables that were disconnected in step 2.
6. Reattach the display assembly to the device.
See
88
"Replacing the Display Assembly" on page 86
Dispose of the old LVDS converter board in compliance with all applicable
local and federal laws.
"Replacing the Display Assembly" on page 86
MAC™ 3500
for instructions.
for instructions.
2046275-019H