Table of Contents
Advertisement
4.
Remove the five Torx fasteners from inside the paper tray shown in the following
figure.
5.
Remove the two fasteners that secure the display panel cover at the back of the
unit and then remove the display cover.
6.
Remove the two fasteners holding the two ground wires on either side of the
display.
7.
Remove the two fasteners at the top of the display panel bracket.
8.
Pivot up the display to access the cable connections on the main PCB.
NOTE:
2046275-019H
If a KISS pump is installed, remove it in order to access the display panel
connectors from the main board. See
on page
89.
MAC™ 3500
"Replacing the Optional KISS Pump"
Maintenance
85
Hide quick links:
Advertisement
Table of Contents
