Table of Contents
Advertisement
Maintenance and cleaning
4.2
Cleaning the spray gun and replac
Caution
Never place the spray gun or parts of the spray gun in cleaning agent!
When pulling out and inserting the wear parts, ensure that the charging body is not
damaged!
2
1
Pemtg3_0005b
It is also possible to dismantle the charging body and merely replace the parts affected by
wear.
12
13
04/2006
ing the wear parts
3
4
6
7
9
11
10
Pemtg3_0006
0351717
•
Pull the deflector cone 1 off the
charging body 4.
•
Unscrew the outer nut 2 from the spray
gun housing 5.
•
Carefully pull the nozzle body 3 off the
powder tube 6.
•
Carefully pull the charging body 4 out
of the powder tube 6.
•
Check the removed parts for wear.
The entire charging body can be
5
replaced with a new one.
•
Carefully Unscrew the tip 8 from the
threaded rod 7 and dismantle the
charging body.
•
Unscrew the air nozzle 12 from the
deflector cone rod 13 if worn and
replace it with a new one.
•
Complete clean residual powder from
all parts.
•
8
Replace worn parts with new ones.
•
Reassemble the charging body.
•
Carefully push the charging body into
the gun and reassemble the gun.
- PEM-TG3
17
Advertisement
Table of Contents
