2.4
Grounding
For safety reasons, the spray gun must be properly grounded. This occurs through the
grounding screw.
Good grounding of the workpiece is also necessary for optimum powder coating.
A poorly grounded workpiece causes:
•
dangerous electric charging of the workpiece
•
back-spray onto spray gun and user
•
uneven coating
•
very bad wrap around
Warning
Sparks between workpiece and conveyor hooks (hangers) can occur if hooks or
other hanger parts are not completely cleaned!
These sparks can cause heavy radio frequency interference.
12
0351701
- PEA-T3XL
Preparing the spray gun
0203_ .doc
05 / 2009