Table of Contents
Advertisement
4
Saving a Color Mode or Fixed Color
When power is switched off to the ColorVision™ lights, the last color show mode or fixed
color will be saved. The next time the light is powered on, the previously saved color show
mode or fixed color will be displayed. For example, while in Party Mode switch the light off.
Wait more than 10 seconds, switch the light back on to resume Party Mode.
During the Off/On switching process, before the selected color is displayed, no
illumination will occur. This operating mode is normal during the switching process.
During this period the pool and spa will be dark and precautions should be taken to
avoid unforeseen accidents. Failure to observe this warning may result in serious injury
or death to pool and spa users.
Selecting a ColorVision Light show mode or fixed color using
an IntelliBrite
Instead of using a wall switch, ColorVision
Lights can controlled with the IntelliBrite
Controller (P/N 600054, sold separately). The
IntelliBrite controller provides complete control
of your ColorVision lights. It's easy to select
a lighting feature, just dial in any one of the
pre-programmed color light shows or fixed
colors. Using the Hold and Recall buttons you
can also create endless unique lighting effects.
The IntelliBrite controller can control individual
or multiple 12 VAC transformers to control
ColorVision lights. Multiple ColorVision lights can be connected via a junction box to
the Controller so that all lights can be switched on and off together. The IntelliBrite
controller can also control multiple ColorVision and IntelliBrite lights.
Note: For IntelliBrite controller wiring instructions, see page 26-27.
Using the IntelliBrite Controller: ColorVision lights are compatible with IntelliBrite colors
and shows and can be synchronized with IntelliBrite color pool/spa and landscape lights.
To select a color light show mode or fixed color mode, rotate the dial so that it points to the
desired selection. The color mode selections start in a clockwise direction from the
9 o'clock position.
Hold and Recall Feature
Note: When ColorVision lights are powered on, the previously selected color is displayed,
unless the HOLD or RECALL feature was previously enabled.
Hold button/LED: Press this button (LED on) to capture and save a color effect while
displaying one of the light show modes. When the button is pressed, the LED will be on,
indicating that the color effect is captured.
Recall Button/LED: Use this button (LED on) to activate the last saved color effect. When
the button is pressed, the LED will be on, indicating that the color effect is being displayed.
COLORVISION Light Installation and User's Guide
®
Controller
®
IntelliBrite
Controller
PRINTED ON: 7/29/2009, 600054_ctlg pics.SLDASM
Hide quick links:
Advertisement
Table of Contents
