Pentair COLORVISION Installation And User Manual page 21

9. Install the new GloBrite
pulling the power cord from the junction box or transformer, making sure the
locking tabs in the back end of the light are properly aligned with the niche
openings (inside the niche).
10. Place the light installation tool (P/N 620057) over the front of the light. Turn the
tool and light clockwise (less than 1/8th. turn), while pushing inward, until you
feel the stop point. This indicates the light is properly seated, locked and the
niche is completely sealed. Note: If the light does not turn smoothly, pull the
light slightly out and make sure that it's seated properly and the niche is free of
debris, then install the light as described in step 6.
Rotate handle 1/8
turn clockwise to
install or counter-
clockwise 1/8 turn
to remove
Light installation
and remove tool
11. Install the diffuser ring (white ring with many small holes), into the niche; concave
side up, as shown below.
Diffuser Ring
Niche
®
light assembly: Push the light into the niche while
Align and insert tool pins with holes
in front of light
™
GloBrite Light Installation/Removal Tool
Diffuser Ring
installed
into niche
COLORVISION Light Installation and User's Guide
17