Pentair COLORVISION Installation And User Manual page 14

10
7. Using the alignment tabs on the niche, carefully align the sealing gasket and
the faceplate to the niche. Once the faceplate is properly aligned, pierce liner
through faceplate and install the screws.

Alignment tab
Sealing
gasket

Liner
8. Secure the face ring to the niche with the eight (8) #8-18 x 1" self-tapping
screws (provided), see Figure 3 on page 6. Using a No. 2 Philips head
screwdriver, tighten each retaining screw to a torque value of 10.00
(minimum) to 15.0 (maximum) in-lbs to secure the face ring and gaskets
on the niche. DO NOT OVER TIGHTEN THE SCREWS. DO NOT USE A
POWER TOOL TO SECURE THE SCREWS. Over tightening or using a
motorized screwdriver on the sealing ring screws can over torque the screw
threads and damage the niche housing and/or vinyl liner seal.
Figure 4.
COLORVISION Light Installation and User's Guide

Spacer ring

Gasket
Self-Tapping screws
(QTY. 8 - provided)
Vinyl/Fiberglass ring
Gasket
Vinyl
Vinyl spacer ring
Gasket
Niche

Gasket

Face ring