Selecting A Colorvision Light Show Mode Or Fixed Color Using A Wall Switch - Pentair COLORVISION Installation And User Manual

Selecting a ColorVision Light Show Mode or Fixed Color Using
a Wall Switch
ColorVision lights are compatible with IntelliBrite light colors and shows and can be
synchronized with IntelliBrite
selected color is displayed, unless the HOLD or RECALL feature was previously
enabled.. To select a color show mode (1-7) or fixed color (8-12), turn the wall switch
Off/On a specific number of times. Each number (1-15) shown below corresponds to
the number of times to power-cycle the switch to activate a color light show or fixed
color. For details about saving color effects while in Show modes, see "Hold" and
"Recall" feature on page 6.
1 SAm Mode: Cycles through white, magenta, blue and green colors
(emulates the Pentair SAm
2 Party Mode: Rapid color changing building energy and excitement.
3 Romance Mode: Slow color transitions creating a mesmerizing and
calming effect.
4 Caribbean Mode: Transitions between a variety of blues and greens.
5 American Mode: Patriotic red, white and blue transition.
6 California Sunset Mode: Dramatic transitions of orange, red and
magenta tones.
7 Royal Mode: Richer, deeper color tones.
8 Blue: Fixed color.
9 Green: Fixed color.
10 Red: Fixed color.
11 White: Fixed color.
12 Magenta: Fixed color.
13 Hold: Save the current color effect during a color light show.
14 Recall: Activate the last saved color effect.
15 White
Example: To select California Sunset Mode; First switch power on to the light; the
previously selected color is displayed, unless the HOLD or RECALL feature was
previously enabled, then turn the switch off and on six (6) successive times. During the
Off/On switching process, no illumination will occur.
®
lights. First switch power on to the light; the previously
®
Color Light).
COLORVISION Light Installation and User's Guide
3