Pentair COLORVISION Installation And User Manual page 23

14. Install the desired eyeball fitting included into the lens (See Eyeball
Instructions on page 29) by Inserting the eyeball perpendicular into the
eyeball housing opening and rotating to center the eyeball into the eyeball
housing. Be sure it is pressed all the way down to provide a smooth
transition. Adjust the eyeball for proper water direction.
15. Before operating the ColorVision light, fill the pool with water until the light
is completely submerged. Note: The ColorVision™ light should not be
powered for more than 30 seconds if not submersed in water.
16. Final check for proper ColorVision light operation: Switch on the main
switch or circuit breaker to the 12 VAC transformer and the switch that
operates the GloBrite light itself. The light should illuminate when the 12
VAC power is applied. If not recheck the installation steps
Eyeball
COLORVISION Light Installation and User's Guide
19