Pentair COLORVISION Installation And User Manual page 13

2. Place the sealing gasket on the niche and align the gasket screw holes
with the niche as shown below.
3. Place the vinyl spacer on the niche aligning the screw holes, Note: there
is only one correct orientation of the spacer where all screw holes are
aligned with the niche. Fasten with the two (2) #8-18 x 1/2" self-tapping
screws (provided), see Figure 3 on page 8. Using a No. 2 Philips head
screwdriver, tighten each retaining screw to a torque value of 10.00
(minimum) to 15.0 (maximum) in-lbs to secure the face ring and
gaskets on the sump. DO NOT OVER TIGHTEN THE SCREWS. DO
NOT ASSEMBLE WITH POWER TOOLS. Note: Over tightening or using
a motorized screwdriver on the gunite cover can over torque the screw
threads and damage the niche housing and/or vinyl spacer ring.
Note: The vinyl spacer ring must be assembled as shown for the mounting
holes to align; recessed area on the outside of the ring.
4. Install the ColorVision light niche in the pool or spa floor. Set the niche
such that the pool floor is flush with the top of the spacer ring. See Figure
1 on page 6. The niche is ABS so use ABS to PVC cement to connect the
water line and electrical conduit to the niche.
5. Install a sealing gasket on top of the vinyl spacer.
6. Install the vinyl liner.
Spacer ring mounting screws
Spacer ring
Alignment tab
Pool Floor is flush with top of vinyl spacer
COLORVISION Light Installation and User's Guide
9