Pentair COLORVISION Installation And User Manual page 35

3. Install an O-ring on the lens and install the lens over the top of the
niche using the supplier machine screws. Secure the lens with the
eight (8) 8-32 x 1/2" machine screws (provided), see Figure 2 on
page 6. Using a No. 2 Philips head screwdriver, tighten each retain-
ing screw to a torque value of 10.00 (minimum) to 15.0 (maximum)
in-lbs to secure the lens on the niche. DO NOT OVER TIGHTEN THE
SCREWS. DO NOT ASSEMBLE WITH POWER TOOLS. Over tight-
ening or using a motorized screwdriver on the lens screws can over
torque the screw threads and damage the niche housing and/or lens.
Custom cut the nozzle
to achieve desired
plume height
Note: It is recommended to custom cut the flexible nozzle once it is installed
into the pool. Start off by cutting 1" at time until you get the desired plume
and the swirling has stopped. The flexible nozzle is directional so it can be
adjusted for proper water flow to the surface.
COLORVISION Light Installation and User's Guide
31