Acknowledging Error Messages - WAGO -TO-PASS 761 Manual

WAGO-TO-PASS® 761
761-110 Telecontrol Module Compact
Pos : 36.33 /Serie 761 (T O-PASS)/Bedienen/Bedi enen 761-11x/- 21x/-31x Quitti erung Stör mel dung @ 7\mod_1265624442311_21.doc x @ 49950 @ 2 @ 1
7.2

Acknowledging Error Messages

If a waiting time not equal to 0 has been set for the acknowledgment of error
messages, the TO-PASS
messages from the recipient.
Acknowledgement is in the form of an SMS containing the configured response
text, or a simple call by the recipient to the TO-PASS
The TO-PASS
You then receive an acknowledgement SMS containing the identifier, the
response text and the alarm text.
Acknowledgement by phone call is based on the card being used!
Some data cards do not allow voice links, meaning that acknowledgement is only
possible via SMS.
If the message is not acknowledged within the defined waiting time, the TO-
PASS® telecontrol modules sends the error message automatically to the next
recipient entered under addresses and waits again for the defined waiting time for
an acknowledgment.
If none of the defined recipients acknowledge the error message and the number
of repetitions is not set to 0, then the procedure is repeated either until a recipient
acknowledges the error message or the maximum number of repetitions has been
reached.
Pos : 36.34 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 2.0.0
Remote Polling using the TO-PASS® Operating Program
®
telecontrol modules expects an acknowledgment of error
®
telecontrol module registers the call.
®
telecontrol module.
75