Lan/Wan Connections; Important Note About Cabling And Bypass Mode; Powering Up The Appliance - Oracle Talari E100 Hardware Manual

Oracle Talari E100 Hardware Guide

LAN/WAN Connections

When connecting each Ethernet cable (LAN, WAN) to the appropriate connector on
the E50:

Position the cables carefully, so that they do not put strain on the connectors.

Organize cables in bundles such that cables do not intertwine.

Inspect the cables to make sure that the routing and bend radii are
satisfactory. Reposition cables, if necessary.

Install cable ties in accordance with site requirements.

Important Note About Cabling and Bypass Mode

If your Talari appliance is operating in bypass mode, logic used by the appliance
represents the functionality provided by a crossover cable. This may cause a loss of the
link between the Talari appliance and older network devices that do not support Auto-
MDIX when straight-through cables are used to connect the LAN and WAN ports of the
Talari appliance. In such a case, a crossover cable is required from the Talari WAN port
to the network device.
If your network devices support Auto-MDIX capability, the link should be automatically
established when in bypass mode and there should be no need for crossover cables.
Talari recommends testing and verifying this capability with the Talari appliance
powered off for proper operation.
For assistance, please contact your Talari representative, or the Talari Support team.

Powering Up the Appliance

When connecting power to the E50:

Plug the AC power cord into the power adapter. Connect the power adapter to
the appliance.

Plug the AC power cord into an uninterrupted AC power source.

The appliance will start automatically.
The E50 uses 100-240 VAC.
2 3