Manual Install - Oracle Talari E100 Hardware Manual

Oracle Talari E100 Hardware Guide

Manual Install

Site Deployment Criteria:
Manual (Legacy) Install requires physical access to the appliance. The end user will
require a PC which can be connected directly to the AUX port of the Talari Appliance
via an Ethernet cable.
Cable the LAN and WAN ports in accordance with the Talari configuration for the
site. Pre-Deployment Requirements:
The network administrator must have an active configuration which includes a client
package for this site running on the NCN. An appropriate IP address, subnet mask,
and gateway for the management interface should be provided for the on-site user to
configure.
If the network administrator will have access to the new appliance once an on-site user
configures the management interface, proceed to step 4 of Deploying the Talari
Appliance. If not, the on-site user will require the client package from the running
configuration:
12. From the Web Console of the NCN, navigate to Manage Network > Change
Management.
13. Download the active package for the new client site.
14. Send the zipped client package to the on-site user who will be deploying the
appliance.
Deploying the Talari Appliance:
1. Connect the power cord to the E50. Connect the other end to an appropriately
grounded power source. The E50 will power on automatically.
2. Connect your PC directly to the AUX Port of the E50.
3. From the PC connected to the Talari:
a. Change the IP address of your PC to 192.168.0.1.
b. Change the Subnet Mask of your PC to 255.255.255.252.
c. Open a web browser and go to the Talari web console at 192.168.0.2. The
username is talariuser and the default password is talari. We strongly
recommend changing the default password as soon as possible.
d. Select Manage Appliance > Local Network Settings from the pull-down
menu.
e. Set the IP Address, Subnet Mask, and Gateway IP Address for the Talari
as provided by your network administrator.
f. Click Change Settings. If your network administrator will be applying the
configuration package, you may now restore the original network settings
on your PC.
4. To apply the configuration package, navigate to Manage Appliance > Local
Change Management.
5. Click Browse and select the .zip package provided by your network administrator,
then click Upload.
6. When the upload is complete, click Next to proceed to activation.
2 6