Raven SC1 Installation Manual page 26

CHAPTER 3
3. Attach the angle sensor arm to the angle bracket with an M6 bolt, three washers, lock washer, and lock nut
(refer to Figure 5 on page 21). The bolts at the top of the sensor housing should slide into the notches at the
top of the angle sensor bracket.
4. Tighten the locking nut firmly and then loosen it a 1/4 turn so that the angle sensor is able to turn freely.
5. Secure the sensor housing with the supplied washers and lock nuts.
NOTE: Before mounting the angle sensor bracket to the implement, check that the sensor disc can move
freely in the sensor housing when turning the sensor arm. The triangular notches carved in the disc
and housing should line up when the implement is in the center position.
DISC CONTROL
1. Attach the angle sensor bracket to the mounting plate (see Figure 6 on page 22).
2. Turn the disc leg to the straight forward position and direct the sensor arm straight to the rear.
3. Cut the threaded rod to the required length.
4. Wrap the sensor lead in a protective sleeve to prevent it from becoming constricted or damaged.
FIGURE 6. Angle Sensor on Disc Steering System
22 SC1™/TC1 Twin Disc Implement Steer Installation Manual