Table of Contents
Advertisement
the atmosphere or merge with return main at
discharge side of steam trap.
☐ Position the steam trap discharge at least 12" below
the outlet connection on the coil.
☐ Use float and thermostatic traps in the system, as
required by the application.
O/A Pressure Sensor and Tubing
Installation (All VAV units and CV units
with return fan or StatiTrac)
☐ O/A pressure sensor mounted to the roof bracket.
☐ Factory supplied pneumatic tubing installed
between the O/A pressure sensor and the connector
on the vertical support.
☐ (Units with StatiTrac) Field supplied pneumatic
tubing connected to the proper fitting on the space
pressure transducer located in the filter section, and
the other end routed to a suitable sensing location
within the controlled space.
Evaporative Condenser
☐ Remove fan bracket.
RT-SVX24Q-EN
☐ Hookup inlet and drain piping.
☐ Install heat tape if needed.
☐ Setup drain hold or drain on power loss.
☐ Setup Mechanical Float.
☐ Setup drain time.
☐ Setup water quality management (3rd party
system).
☐ Options setup.
☐ Calibrate Conductivity Controller.
☐ Setup blowdown setpoints on the conductivity
sensor.
Energy Recovery Wheel
☐ Verify that the wheel turns freely though a full
rotation.
☐ Confirm that all wheel segments are fully engaged
in the wheel frame and that the segment retainers
are completely fastened.
☐ Confirm the seal adjustment and proper belt
tracking on the wheel rim.
P P r r e e - - I I n n s s t t a a l l l l a a t t i i o o n n
27
Hide quick links:
Advertisement
Table of Contents
