Lift Installation - Harmar Mobility AL215 Axis I Installation & Owner's Manual

INSTALLER
INSTALLATION

LIFT INSTALLATION

1. Raise the plastic base cover when the base
has been fastened to the vehicle floor, and
attach the lift to the base as shown. [Figure 20-1]
2. Be sure to compress all split lock washers
when tightening all fasteners.
3. Cut off remaining All Thread after it is
tightened against the washer. This allows
nut removal to deburr thread as it is removed.
[Figure 20-2]
A L -2 2 5 , A L -4 2 5
a n d A L -4 3 5 S e ri
20
Cut off remaining all
e s Cut o
once nut is tightened against
thread once nut is tightened
washer. This will allow nut
against washer.
removal to deburr thread as
it is removed.
| www.harmar.com | 800-833-0478
HEX NUT
SPLIT LOCK
WASHER
A L -2 1 5
O N LY
remaining all thread
Figure 20-1
Figure 20-2
© 2016 Harmar All Rights Reserved