Base Installation: Truck Bed - Harmar Mobility AL215 Axis I Installation & Owner's Manual

BASE INSTALLATION:
TRUCK BED
1. Place base in corner of truck bed. Attempt to
position as close to the corner as possible while
leaving at least 1" clear around the base on all
sides. [Figure 17-1]
2. Install leg extensions into base tubes and
extend them as far as they will go. The Long Leg
Extension should run parallel with the bumper.
Set screws can be hand-tightened at this time.
[Figure 17-2]
USE EXTREME CAUTION! Examine
area for obstructions or potential
hazards such as gas tank and fuel /
brake / electrical lines.
CAUTION!
3. Recommended practice before drilling.
With base in position, use a tape measure to
estimate the distance in both directions from an
exterior reference point (Ex. outside body panel)
to all three potential bolt holes. Repeat this
underneath the truck bed. [Figure 17-3]
Check framing, bracing, or other nearby
thickened structure on which to mount the
lift. Adjust position of base and leg extensions
to capture as much frame as possible while
avoiding the vehicle's gas tank, spare tire,
suspension components etc.
Inside Lifts - Installation & Owner's Manual
OR
Passenger's Side Base
Driver's Side Base
Long Leg Extension
(AL207)
TEC0091 2016JUN30
INSTALLER
INSTALLATION
Figure 17-1
Standard
Leg
Extension
Figure 17-2
Figure 17-3
| 17
P/N: 630-00076-Rev A