Harmar Mobility AL215 Axis I Installation & Owner's Manual page 5

Inspect lifting strap prior to use.
Ensure the lifting strap is secure
and that it points straight down.
CAUTION!
Failure to do so could result in the
chair or scooter swinging, causing
damage to operator, chair or vehicle.
4. When the lift has cleared the vehicle, press the
"DOWN" button to lower the strap.
Attach the docking device supplied with your
lift. Attach the strap hook to the docking device.
[Figure 3-1]
5. Press the "UP" button to begin raising the
power chair or scooter. [Figure 3-2]
NOTE: On AL435 series lifts, you can press
the `RETRACT´ button to shrink the radius for
rotating into the vehicle. This is especially helpful
for wider chairs or scooters and for narrower rear
vehicle openings. [Figures 3-3]
6. When the chair is raised enough to clear the
bumper/threshold, rotate the chair or scooter
into the vehicle by pressing the "IN" button.
[Figure 3-4]
NOTE: For the AL215 manually rotate the lifting
arm inside the vehicle.
7. When the chair or scooter is fully inside the
cargo area, press "DOWN" until the chair or
scooter is placed firmly on the floor.
Leave some tension on the strap during transport
to eliminate movement of the chair or docking
device.
8. To unload, reverse the process.
Inside Lifts - Installation & Owner's Manual
OPERATING YOUR LIFT
TEC0091 2016JUN30 P/N: 630-00076-Rev A
OWNER
OR
Figure 3-1
Figure 3-2
Figure 3-3
Figure 3-4
| 3