Base Installation: 3Rd Row Folding Seats - Harmar Mobility AL215 Axis I Installation & Owner's Manual

BASE INSTALLATION:
3 ROW FOLDING SEATS
RD
1. Place vertical joiners on back wall of seating
well corner. [Figure 15-1] Use base as template for
position.
2. Establish height by having mounting holes
show over threshhold. [Figure 15-2] Attach joiners,
using small screws provided, to lock height.
3. Preferred Installation. Mandatory when lifting
heavier payloads.
• Drill two 3/8" holes in floor of well using
joiners as template. Fasten 3/8" hardware
(x2). [Figure 15-3]
• PLUS Drill two 3/8" holes through back well
wall using joiners as template to accept full-
threaded 3/8" bolts.
VERIFY THAT ALL MATING SURFACES ARE FLUSH.
4. Fold third-row seating back into well. Verify
vertical joiner mount holes are above threshold.
[Figure 15-4]
5. Attach vertical joiners to base using supplied
hardware as indicated. [Figure 15-5]
6. Insert telescoping leg. Attach swivel leg. Drill,
or where possible, use J-hook to seat attachment
point and secure leg. [Figure 15-6]
Tighten all fasteners.
VEHICLE's THRESHOLD
Figure 15-4
Inside Lifts - Installation & Owner's Manual
O N
C E
P L A O O R
L F L
W E L
SE AT
US ED FO R
AT TA CH ME NT
PO IN T
Figure 15-5
INSTALLATION
Fold up third
VEHICLE's
THRESHOLD
row seating
INSTALLATION
WASHERS
SW IVE L
T E L E
LEG
S C O
P IN G
L E G
TEC0091 2016JUN30
INSTALLER
1" or 2"
CHOOSE
HOLE FOR
CLOSEST
TO WALL
POSITION
OBTAIN
DISTANCE
Figure 15-1
THRESHOLD
Figure 15-2
Drill two 3/8" holes
through back well
wall using joiners
as template to
accept fully
threaded
3/8" bolts.
Figure 15-3
Figure 15-6
| 15
P/N: 630-00076-Rev A