Swegon GOLD RX Manual page 32

Alarm No.
Alarm text
Function
71:2 1052 HC COMPRESSOR MOTOR CONTROL START-UP FAILURE
The compressor motor does not rotate during start up.
71:3 1053 HC COMPRESSOR MOTOR CONTROL OVER OR UNDER
VOLTAGE
Low or high power supply to compressor motor control.
71:4 1054 HC COMPRESSOR OUTSIDE WORKING RANGE
HC compressor works outside its ordinary working
range.
71:9 1059 HC EXPANSION VALVE CONTROL CIRCUIT 1 COMMU-
NICATION ERROR
The air handling unit's control unit cannot establish
correct communication with the HC expansion valve
control circuit 1.
72:1 1066 HC HIGH PRESSURE MONITOR CIRCUIT 1 TRIPPED
The high pressure monitor alarm HC circuit 1, has
tripped.
72:2 1067 HC HIGH PRESSURE CIRCUIT 1 ABOVE ALARM LIMIT
The high pressure alarm HC circuit 1, has tripped.
72:3 1068 HC THERMOSTATIC CONTACT CIRCUIT 1 TRIPPED
The thermostatic contacts alarm HC circuit 1, has
tripped.
72:4 1069 HC HOT GAS TEMPERATURE CIRCUIT 1 ABOVE ALARM
LIMIT
The hot gas temperature alarm HC circuit 1, has tripped.
72:5 1070 HC HOT GAS TEMPERATURE CIRCUIT 1 DEFECTIVE
Hot gas temperature sensor is defective or is not con-
nected.
72:6 1071 HC HIGH PRESSURE SENSOR CIRCUIT 1 DEFECTIVE
High pressure sensor HC circuit 1, is defective or is not
connected.
72:7 1072 HC LOW PRESSURE SENSOR CIRCUIT 1 DEFECTIVE
Low pressure sensor HC circuit 1, is defective or is not
connected.
72:8 1073 HC SUCTION GAS TEMPERATURE CIRCUIT 1 DEFECTIVE
Suction gas line temperature sensor HC circuit 1, is
defective or is not connected.
72:9 1074 HC PRESSURE DIFFERENCE CIRCUIT 1 BELOW ALARM
LIMIT
The pressure difference HC circuit 1, has tripped.
72:10 1075 HC SERVICE OF CIRCUIT 1 AND COMPRESSOR
Service of circuit 1 and compressor required.
72:11 1076 HC OVERHEATING TEMPERATURE CIRCUIT 1 BELOW
ALARM LIMIT
HC overheating temperature circuit 1 falls below the set
alarm limit.
72:12 1077 HC PRESSURE EQUALISATION OF LOW PRESSURE CIR-
CUIT 1
HC pressure equalisation low pressure circuit 1, has
tripped.
72:13 1078 HC PRESSURE EQUALISATION OF HIGH PRESSURE
CIRCUIT 1
HC pressure equalisation high pressure circuit 1, has
tripped.
72:14 1079 HC LOW PRESSURE CIRCUIT 1 BELOW ALARM LIMIT
HC low pressure circuit 1 falls below the set alarm limit.
32 www.swegon.com
GB.GOLDSKFLARM.190920
Priority Stop
0 = Blocked 0 = In oper. s = second
A = A alarm 1 = Stop m = minute 1 = automatic
B = B alarm h=hour
A 0
A 0
A 0
A 0
A 0
A 0
A 0
A 0
A 0
A 0
A 0
A 0
A 0
B 0
A 0
A 0
A 0
A 0
We reserve the right to alter specifications without notice.
Delay Resetting
0 = manual
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1
10 s 1