WAGO 750-637/040-001 Manual page 35

WAGO-I/O-SYSTEM 750 XTR
750-637/040-001 Inc. Encoder 24 VDC Diff 32Bit XTR
Table 28: Control byte C1
Bit 7
0
MapPZD
MapPZD
DisCam1
DisCam2
SetCam1
SetCam2
EnableRef
0
Bit 6 Bit 5
Enable Ref Set
Cam2
Coding of Process Data
Coding of Process Data
Inhibit Cam Output 1
0: Cam output 1 enabled.
1: Cam output 1 inhibited.
Inhibit Cam Output 2
0: Cam output 2 enabled.
1: Cam output 2 inhibited.
Apply Cam Output 1
Set value applied as lower comparison value N1_LO for
Positive edge:
cam output 1 (N1).
Set value applied as the upper comparison value N1_HI
Negative edge
for cam output 1 (N1).
Apply Cam Output 2
Set value applied as lower comparison value N2_LO for
Positive edge:
cam output 2 (N2).
Set value applied as the upper comparison value N2_HI
Negative edge
for cam output 2 (N2).
Enable REF Input
The control system sets the EnableRef bit
The control system must enable EN_LATC (C0.0) or
EN_LAT_EXT (C0.1) with a positive edge
A positive edge is generated at input REF
After this, the next positive edge at input C or LATCH
will result in a capture or preload event
Reserved
Control Byte C1
Bit 4 Bit 3
Set Dis
Cam1 Cam2
Process Image
Bit 2 Bit 1 Bit 0
Dis MapPZD MapPZD
Cam1
Manual
Version 1.1.0
35