Elevator Control Horn Installation; Elevator Pushrod Installation - Black Horse Model BLADE BH 70 Instruction Manual Book

BLADE -
ITEM CODE: BH70-A.
 6. After the epoxy has fully cured, remove
the masking tape or T-pins used to hold the
stabilizer in place and carefully inspect the
glue joints. Use more epoxy to fill in any
gaps that were not filled previously and
clean up the excess using a paper towel and
rubbing alcohol.
C/A glue

ELEVATOR CONTROL HORN INSTALLATION.

Elevator control horn install as same as the
way of aileron control horn. Please see pic-
tures below.
Elevator control horn.
2 x12mm.
Drill a hole 1.5mm
diameter.
16
Epoxy glue
INSTRUCTION MANUAL
Secure.

ELEVATOR PUSHROD INSTALLATION.

 Elevator pushrod install as same as the way
of aileron pushrod. Please see pictures be-
low.
M2 lock nut.
Elevator
pushrod