ELDRO-Assembly-manual-344029-EN.docx
CAUTION
Sudden power failure or switch-off due to any c springs, brake
springs, brake weights that may be installed or due to other
external influences
Risk of crushing due to the lifting rod.
– Before removing the ELDRO
drive must be secured, as the lifting rod retracts
automatically.
NOTE
The lifting rod must not be damaged or contaminated (e.g. by paint
as a result of painting the entire system). A failure to observe this
will destroy the lifting rod.
NOTE
The fastening bolts on the foot hole and the lifting rod must be
secured reliably to prevent them slipping out (e.g. using cotter
pins).
NOTE
The ELDRO
®
thruster must not be subjected to any loads at an
angle to its working direction. If installed upright, there must be no
additional load beyond its own weight.
When replacing old ELDRO
with the current version, the manufacturer must be contacted
due to the different installation dimensions.
Assembly and installation
®
thrusters, the downstream
®
thruster versions with thrusters
6
Assembly
6.1
53 / 83