JLG 260MRT Operation And Safety Manual page 86

SECTION 7 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
NOTE: Be sure to lubricate like items on each side
NOTE:
Recommended lubricating intervals are based on machine oper-
ations under normal conditions. For machines used in multi-shift
operations and/or exposed to hostile environments or condi-
tions, lubrication frequencies must be increased accordingly.
Operate hydraulic functions through one complete cycle before
checking hydraulic oil level in tank. Oil should be visible in ADD
sight window on hydraulic tank. If oil is not visible, add oil until
oil is visible in both ADD and FULL sight windows on tank. Do
not overfill tank.
1. Hydraulic Oil
Lube Point - Fill Level/Drain Plug
Lube - HO
Interval - Check oil every 10 hours of operation; change oil
every 2 years or 1200 hours of operation.
2. Hydraulic Filter Element
Interval - Initial change 40 hours, every 250 hours of opera-
tion thereafter.
3.
Engine Compartment
a. Engine Oil Check/Fill
Capacity - See Engine Manual
Lube - See Engine Manual
7-10
Interval - Check level daily; change per manufacturer's
engine manual.
b. Air Cleaner
Lube Point - Filter Element
Interval - Check every 3 months or 150 hours; change
every 6 months or 300 hours.
c. Fuel Filter
Lube Point - Filter Element
Interval - Clean every 3 months or 150 hours; change
every 6 months or 300 hours.
4.
Sliding Wear Pads
Lube Points - 8 Sliding Wear Pads
Lube - MPG
Interval - Every month or 50 hours.
5. Drive Hub
Lube Point - Fill Plug
Lube - EPGL
Interval - Every 2 years or 1200 hours
31215865