OfficeServ 7100
TECHNICAL MANUAL
PART 10. ADDING CARDS TO THE SYSTEM
10.1 ADDING STATIONS AND TRUNKS
1) Power the OfficeServ 7100 OFF before adding a new card. Locate a suitable empty
card slot. Having located a suitable slot, insert the new card into the slot and push
firmly in the middle of the card to ensure that it is fully inserted into the back plane
connector.
2) After the new cards are inserted, the system must be told to recognize the new
cards. This is done through the use of MMC 806 Card Pre-Install. Use this MMC for
each new card that is installed.
3) The new cards must be assigned directory numbers according to the system
numbering plan in MMC 724. The technician must know the software port
assignments of the new cards so the ports can be assigned correct numbers.
10.1
Table of Contents
Home Page
INSTALLATION
PART 10 APRIL 2007