Adding Cards To An Existing System; Adding An Smisc Card; Adding A 2 Sli Card - Samsung iDCS 100 Installation Section

iDCS 100
TECHNICAL MANUAL
PART 11. ADDING CARDS TO AN EXISTING
SYSTEM

11.1 ADDING AN SMISC CARD

1. Check the battery switch on the MEM3 or MEM4 card and make sure it is ON.
2. Turn off power to the system and unplug the power cord.
3. Insert the SMISC2 card into the slot labeled MISC.
4. Restore power to the system.
5. Open system programming and use
6. Use MMC 724 to assign directory numbers to the ports on the card. The port
numbers and recommended directory numbers are listed in the table below. These
directory numbers are the same as the numbers that would have been assigned
when the system was first installed.
ITEM
AA PORT 1
AA PORT 2
AA PORT 3
AA PORT 4
MOH/BGM 2
PAGE OUTPUT 2
RELAY 1
RELAY 2
RELAY 3
ALARM SENSOR

11.2 ADDING A 2 SLI CARD

1. Check the battery switch on the MEM3 or MEM4 card and make sure it is ON.
2. Turn off power to the system and unplug the power cord.
3. Insert the 2 SLI card into the slot labeled SLI.
4. Restore power to the system.
5. Open system programming and use
6. Use MMC 724 to assign directory numbers to the ports on the card. The port
numbers for the 2 SLI are listed in the following table.
MMC 806 to initialize the card.
PORT NUMBER
023
024
025
026
027
028
029
030
031
032
MMC 806 to initialize the card.
11.1
INSTALLATION
PART 11 JUNE 2002
DIRECTORY NUMBER
381
382
383
384
372
362
363
364
365
352
HOME
PAGE
Table of
Contents