Samsung OfficeServ 7100 Technical Manual page 68

OfficeServ 7100
TECHNICAL MANUAL
The OfficeServ 7100 system supports only one dry contact for the common bell. The
MISC port is located on the front panel of the MP10.
Dry contact
(For common bell)
WARNING: Do not attempt to connect commercial AC power to these contacts.
1) After connecting a common bell, you must assign it in MMC 601 to a group as a
ring destination by using the code for common bell.
2) After wiring to the contact pair, set contacts for continuous or steady operation.
3) Next, program hunt group to include the common bell.
4) Assign the trunk to ring the hunt group containing the common bell. Common bell
control can be used with station hunt groups, individual stations and universal
answer.
7.2.5 Ring Over Page
When a customer-provided paging system is installed, incoming calls can be assigned
to ring over page. Program the C.O. line or C.O. lines to ring a hunt group. Using MMC
601 assign the DN number of the Page Output (voice) for the MISC port being used as
a member of the group or as the NEXT PORT for the overflow destination. Other
stations may be assigned to the same group to provide ringing to phones and the
paging system at the same time.
FUNCTION # in MMC 724
7.2.6 Connecting OfficeServ Installation Tool
Installation Tool is a computer application that provides various maintenance and
management functions for the OfficeServ 7100. The minimum requirements for a PC
running Installation Tool are as follows:
Figure 7.19 Connecting Common Bells
MISC
02
7.16
Home Page
INSTALLATION
PART 7 APRIL 2007
DEFAULT
DN
361
Table of Contents