Samsung OfficeServ 7100 Technical Manual page 63

OfficeServ 7100
TECHNICAL MANUAL
ATTACHING iDCS 14 BUTTON MODULES TO AN iDCS KEYSET
To add an iDCS 14 Button Key Strip to your iDCS keyset follow these steps:
Figure 7.15)
1) Place the keyset face down on a flat surface.
2) Remove the base pedestal by placing your thumbs over the attachment clips and
press outward while simultaneously pressing down on the keyset body with your
fingertips.
3) Remove the ribbon cable knockout from the bottom of the keyset.
4) Clip the 14 button strip to the side of the keyset.
5) Plug one end of the ribbon cable into the keyset and the other end into the 14
button strip.
6) Place the support bracket over the ribbon cable and secure with the six screws
provided.
7) Reattach the base pedestal.
Figure 7.14 Attaching iDCS 64 Button Module to an iDCS Keyset
7.11
Table of Contents
Home Page
INSTALLATION
PART 7 APRIL 2007
(see