Samsung OfficeServ 7100 Technical Manual page 21

OfficeServ 7100
TECHNICAL MANUAL
• Switches 1 through 4 select the country the system is installed in.
4
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Switch 5 reserved.
These DIP switches will not take effect unless the switches are set in the wanted
position and the system memory is cleared manually by using the Memory Backup
switch.
3.2.2 Installing Optional Daughter Cards on the MP10
Three (3) types of optional daughter cards can be installed on the MP10:
1) Optional Modem daughter card can be installed in the connector located towards
the back of the MP10.
2) The optional 4SWM PoE LAN daughter card (installed in the connector located
towards the front of the MP10)
3) The optional 4DLM daughter card (installed in the connector located towards the
front of the MP10)
The optional modem daughter card is mounted to connector P7 of the MP10 card.
This modem daughter card allows remote dial up connection to the system for system
administration and configuration. This is an alternative method for connecting to the
system when a LAN/WAN connection is unavailable. The MODEM board has the
following functions:
• The MP10 board supports a 2-Wire Full Duplex modem board. This is the same
modem used on the OfficeServ 500 system.
• The Modem board operates in OfficeServ 7100 via V.24 interface. In addition, the
Modem board supports V.90 protocol. OfficeServ 7100 controls the Modem board
via serial communication using standard AT commands. When mounting a modem
card, the holes on the corners of the modem should be aligned such that the
spacer fits in the hole in the following figure.
3 2
OFF OFF
OFF OFF
OFF ON
OFF ON
ON OFF
ON OFF
ON ON
ON ON
3.4
Home Page
PART 3 APRIL 2007
1 Country
OFF Korea
ON USA
OFF UK
ON Italy
OFF Australia
ON New Zealand
OFF Holland
ON Denmark
Table of Contents
INSTALLATION