Two-Post Installation; 1U Front-Rack Installation - Dell EMC SD-WAN Edge 3000 Series Installation Manual

Two-post installation

To configure your rack for installation, use the two-post rack mounting system that is provided. To complete this installation, supply four
rack-mounting screws.
To begin installation, separate each rail assembly by sliding the inside rail out of the outside rail.
NOTE: For more installation instructions, see the installation labels attached to the rail assembly.

1U front-rack installation

1. Attach the inner platform rails to the Edge 3000 Series platform.
Line up the half-holes on the rail with the mounting heads on the platform and attach the rail to the platform. Slide the rail back until it
locks into place.
2. Repeat on the other side of the platform.
3. Attach the outer platform rails to the two-post rack rails using two user-supplied screws on each side.
4. After you install both rails, line up the platform rails with the installed rack rails. Slide the platform in until it is flush with the front of
rack.
Approximately three inches before you fully insert your platform, the rail locking feature engages to keep the platform from
inadvertently sliding out and falling.
16 Edge 3000 Series installation