Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Dell EMC Edge 600 Series
Summary of Contents for Dell EMC Edge 600 Series
- Page 1 Dell EMC SD-WAN Edge 600 Series Installation Guide Abstract The Dell EMC SD-WAN Edge 600 Series Installation Guide provides site preparation recommendations, step-by-step procedures for installing your device, and connecting to a power source. Dell EMC Networking February 2021 Rev. A03...
- Page 2 Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your product. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death.
-
Page 3: Table Of Contents
Contents Chapter 1: About this guide......................5 Related documents................................6 Information symbols................................6 Chapter 2: Dell EMC SD-WAN Edge 600 Series................7 Introduction................................... 7 Features....................................8 Physical dimensions................................9 LEDs......................................9 Edge 600 series configurations............................10 Prerequisites..................................11 Chapter 3: Site preparations......................12 Site selection..................................12... - Page 4 Taiwan.................................... 30 Singapore certification of compliance........................30 Ukraine certification of compliance........................30 Product recycling and disposal............................30 Chapter 7: Dell EMC support....................... 32 Contents...
-
Page 5: Chapter 1: About This Guide
Read this guide before unpacking the device. For unpacking instructions, see Unpack. Regulatory The marketing model Dell EMC SD-WAN Edge 600 Series (610, 620, 640, and 680) is represented by the regulatory model E24W and the regulatory type E24W001. Table 1. Regulatory compliance information for the Edge 600 series of systems... -
Page 6: Related Documents
Related documents For more information about the Dell EMC SD-WAN Edge 600 Series, see the following documents: ● Dell EMC SD-WAN Edge 600 Series Quick Start Guide ● Dell EMC SD-WAN Edge 600 Series Release Notes NOTE: For the most recent documentation, see the Dell EMC support site at www.dell.com/support. -
Page 7: Chapter 2: Dell Emc Sd-Wan Edge 600 Series
(VNFs). It is a fixed desktop form factor with an optional rack mount kit. The Edge 600 series connects the service provider edge or small-to-medium branch locations to the cloud. There are six 1 GbE ports with two 1 GbE small form-factor pluggable (SFP) or 10 GbE small form-factor pluggable plus (SFP+) ports, depending on the platform type. -
Page 8: Features
5. Four 1 GbE GE3-6 or SFP1-2 default WAN connections 6. DC Power connection The Edge 600 series includes two USB 3.0 Type-A ports on the right and left sides of the platform. Figure 4. USB 3.0 Type-A ports (side) -
Page 9: Physical Dimensions
● 20.8 cm x 20.0 cm x 5.2 cm (W x D x H) LEDs The Dell EMC SD-WAN Edge 600 series has a service indicator LED display on the front of the platform. This indicator displays the status of the platform, the WAN connection, and the VMware service. -
Page 10: Edge 600 Series Configurations
Right side Blinking green Activity (green): No activity Edge 600 series configurations You can order the Edge 600 series in several different configurations. Table 4. Edge 600 series configurations Model Configurations Edge 610 ● 2-core CPU ● Six 1 GbE Ethernet ports ●... -
Page 11: Prerequisites
Site preparations Edge 600 Series installation. ● Dell EMC SD-WAN Edge 600 Series (610, 620, 640, or 680) platform ● Country and region-specific AC power cable ● External AC to DC power supply ● Rubber feet for desktop use and wall mount accessories ●... -
Page 12: Chapter 3: Site Preparations
Site preparations The Edge 600 Series platform connects the service provider edge or small-to-medium branch locations to the cloud, to host virtual network functions. Use the platform on a desktop or optionally install the platform in a wall or rack. -
Page 13: Fans And Airflow
Fans and airflow Fan installation is done at the factory. The Edge 600 series supports forced airflow from the sides and back of the enclosure. ● 2-core—no fan ● 4-core—single fan ● 8-core—two fans ● 16-core—two fans Position the platform in a well-ventilated environment with clearance around the exhaust vents. The fan speed varies based on internal temperature monitoring. -
Page 14: Chapter 4: Edge 600 Series Installation
4. Remove all packing material. 5. Inspect the product and accessories for damage. Desktop mount The Edge 600 Series includes four rubber pads that provide secure and stable placement of the platform on a clean, flat surface. NOTE: Ensure the platform is in a well-ventilated environment with clearance around the exhaust vents. -
Page 15: Wall Mount Installation
Ensure the platform is in a well-ventilated environment with clearance around the exhaust vents. Steps 1. The Edge 600 series unit includes a wall mount bracket with cross-shaped cutout for the mounting screws. The wall mount bracket includes cross-shaped cutouts for the mounting screws. - Page 16 2. To mount the Edge 600 series unit to the wall using the wall mount bracket provided, you must first anchor the screws into the wall surface. Depending on the type of wall surface, use the M3 screw and anchor to ensure a secure installation.
-
Page 17: Rack Mount
Figure 8. M3 screw installation points 4. After the brackets have been attached to the Edge 600 series unit and the screws are mounted into the wall, place the brackets over the screws and slide the unit to one side to secure the unit in place. -
Page 18: Optics Modules
The Edge 610 system has SFP ports as where the Edge 620, Edge 640, and Edge 680 systems have SFP+ ports. To support 1 Gbps mode, the Edge 600 platform supports Dell EMC SFP 1 Gbps optic modules. ● 10 GbE SFP+ ports support any 1 G/10 G, SX/SR or LX/LR, dual-speed optical module. -
Page 19: Platform Setup
● The ambient temperature around the platform, which may be higher than the room temperature, is within the limits that are specified for the Edge 600 Series. For more information, see Specifications. ● There is no source of heat near the unit. - Page 20 4. If you received an email from your IT administrator, follow the instructions in the email to complete the Edge activation. If you did not receive an email, request the setup instructions for your IT administrator or contact your Dell EMC sales representative.
- Page 21 Figure 14. Edge 600 series default LAN ports GE1 and GE2 Next steps After following these instructions, if you are still unable to activate the Edge, contact your Dell EMC sales representative. Edge 600 Series installation...
-
Page 22: Chapter 5: User Interface
User interface You can activate and troubleshoot basic functionality of the Edge 600 series by connecting your laptop or mobile device using one of the default LAN ports (GE1 or GE2) or through the Wi-Fi connection. For additional information about initial activation,... -
Page 23: Chapter 6: Specifications
Specifications This section lists the Edge 600 Series specifications. NOTE: For RoHS information, see Restricted Material Compliance. Topics: • Chassis physical design • IEEE standards • Safety standards and compliance agency certifications • Agency compliance • Product recycling and disposal Chassis physical design Table 6. -
Page 24: Ieee Standards
● IEC 60950-1, 2nd Ed, including all National Deviations and Group Differences Agency compliance The Edge 600 Series complies with the following safety and agency requirements: USA Federal Communications Commission statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. -
Page 25: Fcc Caution
Consult the dealer or an experienced radio/TV technician for help. FCC caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. -
Page 26: Radiocommunication Equipment Compliance For Thailand
Avertissement: 1. Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à l’intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux; 2. Les pires angles d’inclinaison nécessaires pour rester conforme à l’exigence de la p.i.r.e. applicable au masque d’élévation, et énoncée à... -
Page 27: European Union
Brazilian certificate European Union EU Declaration of Conformity Declaration #550004 for Velocloud Edge Wireless Gateway Model: Edge510 Manufactured by: Velocloud Networks, Inc. Address: 3401 Hillview Ave Palo Alto, CA 94304 This Declaration of Conformity is issued under the sole responsibility of Velocloud Networks for: Product Name: Velocloud Edge WirelessGateway Model: Edge 510 The above product has been assessed and found to be in conformity with the essential requirements of the following EU Directives:... -
Page 28: Japan Vcci Compliance For Class A Equipment
Equipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, the user may be required to take corrective actions. NOTE: Use the AC power cords with Dell EMC equipment only. Do not use Dell EMC AC power cords with any unauthorized hardware. Figure 16. Japan: warning label... -
Page 29: Korean Certification Of Compliance
BTE compliance certificate Japanese BTE compliance certificate Korean certification of compliance Korean certification of compliance Figure 17. Korean package label Radio compliance certificate Korea (Korean warning statement is only required for devices contain 2400~2483 and/or 5725~5825 MHz radios) 해당 무선설비는 운용 중 전파혼신 가능성이 있음 Korean radio compliance certificate Mexico Mexican compliance. - Page 30 You must recycle or discard this appliance according to applicable local and national regulations. Dell EMC encourages owners of information technology (IT) equipment to responsibly recycle their equipment when it is no longer needed. Dell EMC offers a variety of product return programs and services in several countries to assist equipment owners in recycling their IT products.
- Page 31 EEE on the environment and human health due to the potential presence of hazardous substances in EEE. Dell EMC products, which fall within the scope of the WEEE, are labeled with the crossed-out wheelie-bin symbol, as shown above, as required by WEEE.
- Page 32 Dell EMC support The Dell EMC support site provides documents and tools to help you effectively use Dell EMC equipment and mitigate network outages. Through the support site you can obtain technical information, access software upgrades and patches, download available management software, and manage your open cases. The Dell EMC support site provides integrated, secure access to these services.