Installation; Precautions; Installation Procedure - YOKOGAWA Sushi Sensor XS770A User Manual

3.

Installation

3.1

Precautions

For information about ambient conditions of the installation location, refer to
l
Section 2.4 in "IM 01W06E01-01EN".
Make sure that there are no damages, deformations, or stains adhering to the
l
surface of the Base. Any deformations or stain may affect measurements.
To align the X-axis or Y-axis to the desired orientation, make appropriate
l
adjustments using Sushi Sensor App after mounting. For details, refer to
Section 5.3.
3.2

Installation Procedure

XS770A can be installed using two methods: directly mounting to the measurement target by the
attached screw, or using the magnetic holder (F9096DA) which is an accessory of XS770A.
To install XS770A, follow the procedure described below.
1. Determine the mounting position of XS770A. Find a plain surface with a diameter of 40 mm
(1.57 inch) or more and a thickness of 7 mm (0.28 inch) or more.
2. Mounting this product.
2a. Direct mounting of XS770A
2a.1 Follow the procedure below, make a vertical installation hole.
2a.2 Attach the screw (provided hexagon socket set screw or provided conversion
2a.3 Mount XS770A to the installation hole made on the measurement target, and
2b. Using the magnetic holder
2b.1 Attach the provided hexagon socket set screw to the Base.
2b.2 Attach XS770A to the magnetic holder and tighten the screw using a tool such as
2b.3 Mount XS770A to the installation surface. The magnetic holder has a strong
3. Make sure that there is no loose space in the connection surface between this sensor and
the measurement target, and that no abnormal vibration occurs.
4. Tie the strap hole of this product to a structural object nearby using a string as needed.
Removing procedures are the reverse of the above.
• In case using the hexagon socket set screw, make a screw hole (more than
7 mm deep at M6 P-1) in the mounting position.
• In case using the conversion screw, make a vertical screw hole (more than
0.28 inch deep at UNF1/4-28) in the mounting position.
screw) to the base. If using the conversion screw, screw the M6 side (with no
notch) into the base.
tighten the screw using a tool such as a 46 mm wrench. (Recommended
tightening torque: 5.1 N·m)
a 46 mm wrench or strap wrench. (Recommended tightening torque: 5.1 N·m)
magnetic force. Place the edge of the magnetic holder on the installation surface
once, then carefully install it without moving your hand.
<3. Installation>
IM 01W06E01-11EN
7