Function Code F: Write Performance Test - Quantum LTO-8 HH SAS Technical Reference Manual

Function Code F: Write
Performance Test
QuantumLTO-8 HH SAS User's Guide
• If no error is detected, the diagnostic will loop and begin again.
To stop the loop, press the Unload button for one second and
release. When the diagnostic ends, 0 temporarily appears in the
SCD, and the tape drive exits Maintenance Mode.
• If an error is detected, the Fault light flashes and the drive posts
an error code to the SCD. To determine the error, locate the
code in Appendix A, Error Codes and
error either turn the power off and then on again, or reboot the
drive by pressing and holding the Unload button for 10
seconds.
Approximate Run Time = 7 minutes per loop
Total Number of Loops = 10
Function Code F performs tests to ensure that the drive can read from
and write to tape.
Press the Unload button to stop the diagnostic and exit maintenance
mode. Pressing the Unload button once will abort the test at the end of
the current test loop. Pressing the Unload button twice will abort the
test immediately. Wait for the drive to rewind the tape and unload the
cartridge.
Caution: For this test, insert only a scratch (blank) data cartridge or a
cartridge that may be overwritten. During the test, the
drive overwrites the data on the cartridge.
Note: If you inserted an invalid tape cartridge, error code J or 7
appears in the SCD. If you inserted a write-protected cartridge,
or the media has read-only compatibility, error code P appears
in the SCD. In either case, the tape drive unloads the cartridge
and exits Maintenance Mode after the cartridge is removed.
1 Place the drive in Maintenance Mode. For instructions, see
Maintenance Mode
2 Press the Unload button once per second until F appears in the
SCD. (If you cycle past the desired code, press the Unload button
once per second until the code reappears.)
Diagnostic and Maintenance Functions
on page 48.
Chapter 4: Operations
Messages. To clear the
Entering
59