Quantum LTO-8 HH SAS Technical Reference Manual page 105

Error
Code Cause and Action
8 Interface problem. The tape drive determined that a failure occurred in the tape drive's
hardware or in the host bus. See
running Function Code 6: Run Host Interface Wrap Test
1 Verify the correct interface wrap tool was attached during the test. The test will fail if the
correct interface wrap tool is not attached.
2 If the correct interface wrap tool was attached during the test, replace the drive. The error
code clears when you place the tape drive in maintenance mode.
9 Tape drive or RS-422 error. The tape drive determined that a failure occurred in the tape
drive's hardware or in the RS-422 connection. See
on page 54 to isolate the problem to the drive. The error code clears when you place the
tape drive in maintenance mode.
QuantumLTO-7 HH SAS User's Guide
Chapter 6, Troubleshooting. If 8 was displayed while
Function Code 7: Run RS-422 Wrap Test
Appendix A: Error Codes and Messages
on page 53:
97