Power Button; Single-Character Display (Scd) - Quantum LTO-8 HH SAS Technical Reference Manual

Chapter 4: Operations

Power Button

Power Button

Single-character Display (SCD)

34
copy to tape, copy to flash memory, and erase flash). For more
information, see
The Unload button is used to switch between modes. For more
information, see Unload Button
The Power button is a push button that turns the tape drive on or off.
The button is located on the front panel (see 7 in
When the Power button is in the off position, the primary electrical
power within the enclosure is still active. To remove all electrical power
to the enclosure, unplug the power cord from the receptacle at the rear
of the drive.
When the unit is powered-on but idle, the Ready light (see 2 in
on page 13) is solid green; when it is performing a function, the Ready
light is flashing green.
The SCD (5 in Figure 3
• Error conditions and informational messages
• Diagnostic or maintenance functions (while in maintenance mode
only)
Appendix A, Error Codes and Messages
conditions and informational messages. If multiple errors occur, the
code with the highest priority (represented by the lowest number)
displays first. When the error is corrected, the code with the next
highest priority displays, and so on until no errors remain.
Diagnostic and Maintenance Functions
character codes that represent diagnostic or maintenance functions. To
initiate a function the unit must be in maintenance mode.
Diagnostic and Maintenance Functions
on page 40.
on page 13) presents a single-character code for:
lists the codes for error
on page 45 lists the single-
QuantumLTO-8 HH SAS User's Guide
on page 45.
Figure 3 on page 13).
Figure 3