Manitou MT732ST38 Operating And Safety Instructions Manual page 86

5 - ATTACHMENT HYDRAULIC CONTROL FORCED OPERATION
This OPTION must only be used with an attachment requiring continuous hydraulic movement, such as a brush, feeder
bucket, mixer, spray etc. It is strictly forbidden for use in handling operations and all other applications (winch, crane
Never leave the driver's cab without resetting the potentiometer C to 0%.
Before starting the lift truck, make sure the potentiometer is set to 0%.
CONTINUOUS HYDRAULIC MOVEMENT OF THE ATTACHMENT
- Check that potentiometer C is set to 0%.
- Switch button A to the front or the back (depending on the type of attachment),
press button B and release button A. The red indicator 1 flashes to indicate that it
is in operation.
- Set the required flow rate using potentiometer C.
- To stop continuous hydraulic movement of the attachment, move switch A forwards
or backwards or press button B. Indicator 1 goes out.
- Set potentiometer C to 0%.
NOTE: If the operator leaves the driver's cab, the continuous hydraulic movement
will automatically stop and must be restarted.
6 - TELESCOPE SUSPENSION
The telescope is suspended to dampen jerking of the lift truck on rough ground
(e.g. handling straw in a field).
Boom suspension is active to a lifting height of 3m00 from the axis of articulation of the carriage with respect to the
When you move beyond this height or make another hydraulic movement (tilting, telescoping, attachment), telescope
suspension is momentarily deactivated and the indicator lamp of switch 1 goes out.
OPERATION
- Set the forks or attachment on the ground and raise the front wheels a few centimeters
only.
- Press switch 1 to position A, the visual indicator comes on indicating that telescope
suspension is activated.
- Press switch 1 to position B, the visual indicator goes out indicating that telescope suspension is deactivated.
- When the engine is off, telescope suspension is automatically deactivated.
7 - ATTACHMENT EASY HYDRAULIC CONNECTION
For easy attachment hydraulic connection and disconnection.
OPERATION
- Switch on lift truck ignition.
- Press for two seconds on push-button 1 to release the attachment circuit hydraulic
pressure.
- Connect or disconnect the rapid connectors of the hydraulic attachment (see: 4 -
OPTIONAL ATTACHMENTS FOR USE WITH THE RANGE: PICKING UP THE ATTACHMENTS).
IMPORTANT
jib, crane jib with winch, hook, etc.).
IMPORTANT
ground with the boom retracted.
2 - 55
A
1
B C
1
B
A
1