C - Every 250 Hours Of Service - Manitou MT732ST38 Operating And Safety Instructions Manual

C - EVERY 250 HOURS OF SERVICE

C1 – ANGLE GEAR BOX OIL LEVEL
Park the lift truck on level ground with the boom raised and the engine stopped.
Raise the boom and place the boom safety wedge on the rod of the lifting cylinder (see: 1 - OPERATING AND SAFETY
INSTRUCTIONS: LIFT TRUCK MAINTENANCE INSTRUCTIONS).
- Pull out dipstick 1.
- Wipe the dipstick and check the correct level between the MIN and MAX marks.
- If necessary, add oil (see: 3 - MAINTENANCE: E9 - ANGLE GEAR BOX OIL).
C2 – PARKING BRAKE
Place the lift truck on level ground with the rated load in the transport position.
- Check the tightening adjustment by locking the parking brake in position A.
- Pull on the lift truck rear towing pin with a minimum force of 3500 daN. The wheels
of the lift truck must not rotate.
- Adjust if necessary.
- Progressively tighten the end of the lever 1 and recheck braking.
- Repeat the operation until correct braking is obtained.
C3 – CAB VENTILATION FILTER (AIR CONDITIONING OPTION)
- Unscrew thumbscrew 1 and remove protective casing 2.
- Lift out cab ventilation filter 3 and replace it with a new one (see: 3 - MAINTENANCE:
FILTERS, CARTRIDGES AND BELTS).
- Refit the protective casing.
Carry out the operations described previously as well as the following operations.
IMPORTANT
CHECK
CHECK - ADJUST
CHANGE
3 - 20
1
A
1
B
2
1
3