Manitou MT732ST38 Operating And Safety Instructions Manual page 126

H2 – LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE
According to the use of the lift truck, the device may require to be periodically reset.
This procedure allows this operation to be easily done.
- Provide a fork carrier or a bucket and a load corresponding to at least half the lift truck's rated capacity.
- Preferably perform the reset when the lift truck is still cold (before it is used) or ensure that the temperature of the rear
axle is not more than 50°C.
- Place the lift truck on flat, level ground with the wheels straight.
Carefully follow the boom positioning instructions. Two audible beeps and lighting of the warning indicator lamp
When the reset is complete, check correct operation of the longitudinal stability limiter and warning device (see: 3 - MAINTENANCE: A - DAILY OR EVERY 10 HOURS
STEP 1
START
- Without attachments.
- Boom fully retracted and
raised.
STEP 2
1
- An audible beep.
- First green LED flashing.
- Test button flashing.
2
STEP 3
1
- F i r s t g r e e n L E D
continuously lit.
- Second green LED flashing.
- Test button flashing.
STEP 4
END
- All LEDs lit.
- A continuous audible beep.
IMPORTANT
instructions correctly. If in doubt, contact your dealer.
OF SERVICE).
Simultaneously press and hold down the
"BUCKET" MODE
- Two beeps will sound and all the LEDs will flash twice to confirm the start of the procedure.
- Without attachments.
- Carriage tilted fully backwards.
- Boom fully retracted and in the down position a few centimeters off the ground.
- With the fork carrier or the bucket and a load (keep boom retracted to allow all other
hydraulic movements).
- Boom fully retracted and in the down position a few centimeters off the ground.
IMPORTANT
Keep the load as close to the ground as possible throughout this operation.
- Hold down the disable the "aggravating" hydraulic movement cut-off button
(indicator lamp lit), and telescope the boom until the rear wheels leave the ground.
NOTE: This stage consists in unloading the rear axle. It can be done using a jack but
without bearing on the rear axle.
- After completing the resetting procedure, the lift truck is in an overloaded condition. Retract the telescope
to restore the situation.
3 - 35
will inform you if you have failed to follow these
and TEST
/
/
/
RESET
buttons.
Short press the test
button.
Short press the test
button.
Two beeps will
sound and all the
LEDs will flash twice
to confirm the end of
the procedure.