D6 – PARKING BRAKE LEVER MECHANISM
- Clean and grease hinge pins 1 with grease (see: 3 - MAINTENANCE: LUBRICANTS
AND FUEL).
D7 – CAB VENTILATION FILTER
- Unscrew thumbscrew 1 and remove protective casing 2.
- Lift out cab ventilation filter 3.
- Clean the filter with a compressed air jet.
- Check its condition and change if necessary (see: 3 - MAINTENANCE: FILTERS
CARTRIDGES AND BELTS).
- Refit the filter and protective casing.
D8 – FRONT AND REAR AXLE DIFFERENTIAL OIL
Place the lift truck on level ground with the engine stopped and the differential oil still
warm.
Dispose of the drain oil in an ecological manner.
- Place a container under the drain plugs 1 and unscrew them.
- Remove level plug 2 and filling plug 3 to ensure that the oil is drained properly.
- Refit and tighten the drain plugs 1 (tightening torque 34 to 49 N.m).
- Fill up with oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) through filler port 3.
- The level is correct when the oil level is flush with the edge of opening 2.
- Check for any possible leaks at the drain plugs.
- Refit and tighten level plug 2 (tightening torque 34 to 49 N.m) and filler plug 3
(tightening torque 34 to 49 N.m).
- Repeat this operation for the rear axle differential.
IMPORTANT
3 - 24
GREASE
1
1
CLEAN
1
DRAIN
3
1
1
1
1
2
3
2
1