Manitou MT732ST38 Operating And Safety Instructions Manual page 112

C4 – HEATING BLOCK ONE WAY VALVE
- Since one way valve 1 is located under the cab, it is possible for it to become
obstructed with spattered mud for example. Clean if necessary.
C5 – FRONT AND REAR AXLE DIFFERENTIAL OIL LEVEL
Place the lift truck on level ground with the engine stopped.
- Remove the level plug 1; the oil should be flush with the edge of the hole.
- If necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) through the
filler port 2.
- Refit and tighten the level plug 1 (tightening torque 34 to 49 N.m).
C6 – FRONT AND REAR WHEEL REDUCTION GEAR OIL LEVEL
Place the lift truck on level ground with the engine stopped.
- Check the level on each wheel reduction gear.
- Place level plug 1 in a horizontal position.
- Remove the level plug; the oil should be flush with the edge of the opening.
- If necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) through the
same port.
- Refit and tighten the level plug (tightening torque 34 to 49 N.m).
CLEAN
CHECK
CHECK
3 - 21
1
2
1
1