BMW C 650 GT Rider's Manual page 71

raised to a riding position
higher than the parking
position.
If the windscreen encounters
resistance before it reaches
its limit position the pressure-
sensitive finger guard system
goes active. The windscreen's
movement is stopped.
Automatic movement is
stopped immediately if you
press a rocker switch for the
windscreen.
The windscreen moves back
toward the riding position if you
switch the ignition on again
while automatic movement is in
progress.
Automatic riding position
after ignition ON
The windscreen returns to the
last-used riding position when
you switch on the ignition.
Automatic movement starts
only if the windscreen was
https://www.motorcycle-manual.com/
raised beforehand to a riding
position higher than the parking
position.
Automatic movement is
stopped immediately if you
press a rocker switch for the
windscreen.
The windscreen moves back
toward the parking position
if you switch the ignition off
again while automatic move-
ment is in progress.
After the windscreen's auto-
matic movement ends or is
stopped, with the engine run-
ning you can adjust the wind-
screen by means of the rocker
switches.
Adjusting windscreen
Switching on ignition (
The windscreen moves from
the parking position to the last-
used riding position.
Start the engine to avoid dis-
charging the battery.
Press top section of rocker
switch 1 to raise the wind-
screen.
Press bottom section of rocker
switch 1 to lower the wind-
screen.
46).
5
69
z