General Instructions; Standard Tool Kit; Front-Wheel Stand - BMW C 650 GT Rider's Manual

General instructions

8
The "Maintenance" chapter de-
scribes straightforward proced-
98
ures for checking and replacing
certain wear parts.
Special tightening torques are lis-
ted as applicable. The tightening
torques for the threaded fasten-
ers on your vehicle are listed in
the section entitled "Technical
data".
You will find information on more
extensive maintenance and re-
z
pair jobs in the Repair Manual
on DVD for your vehicle, which
is available from your authorised
BMW Motorrad dealer.
Some of the work calls for spe-
cial tools and a thorough know-
ledge of the technology involved.
If you are in doubt, consult a
specialist workshop, preferably
your authorised BMW Motorrad
dealer.

Standard tool kit

1 Hook wrench
2 Torx wrench, T30
3 Spare fuses with puller tool
Minifuses, 4 A, 7.5 A, 10 A
and 15 A
4 Open-ended spanner
Width across flats 8/10
https://www.motorcycle-manual.com/
Adjusting spring preload
for rear wheel ( 71).
Checking engine oil level
( 100).
Topping up coolant
( 107).
Replace the fuses.
4 Removing battery
( 124).
5 Reversible screwdriver
blade
Phillips PH1 and Torx T25
Removing body panels.
Removing battery
( 124).

Front-wheel stand

Installing the front-wheel
stand
Requirement
The basic stand and its access-
ory parts are available from your
BMW Motorrad dealer.
Make sure the ground is level
and firm and place the Maxi-
Scooter on its centre stand.
Use basic stand with front-
wheel adapter.