Attaching Thin Workpiece Fence; Storage, Transportation, And Mounting; Miter Gauge And Push Stick Storage - Bosch 4100XC Operating/Safety Instructions Manual

1600A01Z1U.qxp_4100XC 10/31/19 1:21 PM Page 21

Attaching Thin Workpiece Fence

Make sure the fasteners 25a are in the outer
two holes. Slide the rip fence 18 away from the
blade. Set the thin workpiece fence on the
table, turn the fasteners so that the heads align
with the slot 18a on the rip fence.
Slide the thin workpiece fence towards the
rip fence handle 18b and align the front edge
of the thin workpiece fence with edge of the
table 2. Tighten the fasteners (Fig. 14a).
Set the thin workpiece fence to the desired dis-
tance from the blade. NOTE: the thin work-
piece fence is 3" (76mm) wide. When using the
rip fence scale, subtract 3" (76mm) from the
scale reading to get the desired setting. For ex-
ample, a scale reading of 4-1/2" (114mm) po-
sitions the thin workpiece fence 1-1/2"
(38mm) from the blade.
To remove the Thin Workpiece Fence, loosen
fasteners and reverse the installation steps.
After removal, tighten fasteners to prevent loss.
Store Thin Workpiece Fence as shown on
page 22.
MITER GAUGE AND PUSH STICK
STORAGE
When not in use, store miter gauge 10 in
miter gauge storage slot 13 on the left side
panel of the saw (Fig. 15).
When not in use, slide push stick 22 into push
stick storage slot 23. Make sure to insert
push stick handle first as shown in Fig. 15.
Assembly

Storage, Transportation, and Mounting

Fig. 14a
25
Fig. 15
23 13 10
25a
18
18a
18b
2
22
21